How to Install Sync Server 1.5 on Qnap NAS?
Hi All.
I'm trying to install the firefox sync server on my qnap (x86 processor with a Embedded Linux ... with QTS 4.2 firmware ) server but i'm getting some problems...
After installing Sync Server 1.5 qpkg from http://forum.qnap.com/viewtopic.php?f=320&t=116178
I'm getting this error when I try to reach http://[Public url]:5000/token/1.0/sync/1.5:
{"status": "error", "errors": [{"location": "body", "name": "", "description": "Unauthorized"}]}
Many thanks pjgmte
Upravil(a) pjgmte dňa
Vybrané riešenie
guigs,
Many Thanks for everything!
Is't working!!!
Problem was in the syncserver.ini file...
I just edit the syncserver.ini file and point the host to the internal ip.
like this...
[server:main] use = egg:gunicorn host = 192.168.1.87 port = 5000 workers = 2 timeout = 30
Čítať túto odpoveď v kontexte 👍 0Všetky odpovede (5)
Hey, So I asked the sync guys, and I would recommend asking in the sync list:
However it may be, as informed by nalexander, that your python tool chain is not installing.
In your error logs there is a network issue as well as an issue retrieving a recovery key. Are you using the older version of Sync? Might really want to email the sync list here.
guigs said
In your error logs there is a network issue as well as an issue retrieving a recovery key. Are you using the older version of Sync? Might really want to email the sync list here.
Hi guigs
network it's fine (I Think) as you can see if you went here:
http://[public url]:5000/token/1.0/sync/1.5
here you we can see {"status": "error", "errors": [{"location": "body", "name": "", "description": "Unauthorized"}]}
before I had {"status": "error", "errors": ["The public_url setting doesn't match the application url.\nThis will almost certainly cause authentication failures!\n public_url setting is: http://localhost:5000\n application url is: http://192.168.1.87:5000\nYou can disable this check by setting the force_wsgi_environ\noption in your config file, but do so at your own risk."]}
it's a improvement right? ;)
Strange is that if I went here http://[public url]:5000
it says that "it works"
lool
Should try again later today because I think can be related with syncserver.ini configuration issues...
My syncserver.ini file -> syncserver.ini
Don't you think?
many thanks! pjgm
Upravil(a) pjgmte dňa
Vybrané riešenie
guigs,
Many Thanks for everything!
Is't working!!!
Problem was in the syncserver.ini file...
I just edit the syncserver.ini file and point the host to the internal ip.
like this...
[server:main] use = egg:gunicorn host = 192.168.1.87 port = 5000 workers = 2 timeout = 30